Like most other operating systems, CLFS is usually installed on a dedicated partition. The recommended approach to building a CLFS system is to use an available empty partition or, if you have enough unpartitioned space, to create one. However, if you're building for a different architecture you can simply build everything in “/mnt/clfs” and transfer it to your target machine.
A minimal system requires around 2.5 gigabytes (GB). This is enough to store all the source tarballs and compile the packages. The CLFS system itself will not take up this much room. A large portion of this requirement is to provide sufficient free temporary storage. Compiling packages can require a lot of disk space which will be reclaimed after the package is installed. If the CLFS system is intended to be the primary Linux system, additional software will probably be installed which will require additional space (2-10 GB).
Because there is not always enough Random Access Memory (RAM) available for compilation processes, it is a good idea to use a small disk partition as swap space. This is used by the kernel to store seldom-used data and leave more memory available for active processes. The swap partition for an CLFS system can be the same as the one used by the host system, in which case it is not necessary to create another one.
Start a disk partitioning program such as cfdisk or fdisk with a command line option
naming the hard disk on which the new partition will be
created—for example /dev/hda for
the primary Integrated Drive Electronics (IDE) disk. Create a Linux
native partition and a swap partition, if needed. Please refer to
cfdisk(8) or fdisk(8) if you do not yet know how to use the
programs.
Remember the designation of the new partition (e.g., hda5). This book will refer to this as the CLFS
partition. Also remember the designation of the swap partition. These
names will be needed later for the /etc/fstab file.